Notes for air compressor
1, the air compressor should be parked away from steam, gas and dust flying place. The inlet pipe shall be equipped with a filter. After the air compressor is in place, apply symmetrical wedge of pad block.
2. Always keep the outside of the storage tank clean. Do not weld or heat process near the gas tank. The gas storage tank shall be hydrostatic tested once a year and the test pressure shall be 1.5 times the working pressure. The barometer and safety valve should be inspected once a year.
3, the operator should receive special training, must fully understand the structure, performance and function of the air compressor and ancillary equipment, familiar with the operation and maintenance procedures.
4, operators should wear good work clothes, female comrades should be braided into the work cap. It is strictly forbidden to operate after drinking, to do anything unrelated to operation, to leave the work station without authorization, and to decide to replace the work of non-machine operators without authorization.
5. Before starting the air compressor, check and prepare according to regulations and open all valves of the storage tank. After starting up, the diesel engine must be heated at low speed, medium speed and rated speed. After paying attention to whether the reading of each meter is normal, it can be operated with load. Air compressor should gradually increase the load start, each part of the normal before the full load operation.
6. During the operation of the air compressor, pay attention to the meter reading (especially the reading of the barometer) at any time, listen to the sound of each part, and stop the machine immediately for inspection if any abnormal situation is found. The atmospheric pressure in the tank shall not exceed the pressure specified on the nameplate. Open the condensate oil and water discharge valve of the intercooler and the storage tank for 1 ~ 2 times every 2 ~ 4 hours. Do a good job of cleaning the machine, air compressor running for a long time, do not use cold water rinse.
7. When the air compressor stops, it shall gradually open the exhaust valve of the storage tank, slowly reduce the pressure, and correspondingly reduce the speed of the diesel engine, so that the air compressor can run for 5 ~ 10 seconds without load and at a low speed. After the air compressor stops, the diesel engine will continue to run at a low speed for 5 seconds and then stop. In winter, if the temperature is lower than 5 ° c, the cooling water not mixed with antifreeze should be discharged after the shutdown.
8. When cleaning the heat sink, do not use combustion method to remove pipe grease. Cleaning, tightening and other maintenance work must be carried out after the shutdown. When washing parts with compressed air, do not aim the tuyere at human body or other equipment to prevent injury or damage.
9. Perform a manual exhaust test on the relief valve of the storage tank regularly (weekly) to ensure the safety and effectiveness of the relief valve.
10, do a good job in the cleaning of the machine, air compressor long-term operation, do not use cold water rinse.
Shenyang weidel energy saving equipment co. LTD
Tel: 024-31556558 13066748717
Email address: firstname.lastname@example.org
Address: door 13, 14, building 5, no. 22-6, hongxing road, yuhong district, shenyang (shenyang wuzhou international industrial expo city)